Xerox DocuMate 515 Betriebsanweisung PDF herunterladen (Seite 18)

DocuMate 515 Scanner User’s Guide 13

Installation

Step 4: Connect the USB Cable and Turn on the Power

The DocuMate 515 scanner connects to any available USB port. Check

your computer’s manual for USB port locations.

1. Remove any protective tape from the USB cable.

2. Plug the USB cable into the USB port on the scanner then into a USB

port on the computer.

If the plug does not attach easily, make sure that you are plugging it in

correctly. Do not force the plug into the connection.

3. Turn on the power switch, located on the back of the scanner to the

right of the power port.

The status light comes on and flashes indicating that the scanner is

receiving power.

If you are using Windows XP or Windows Vista, and have plugged the

USB cable into a USB 1.1 port, an information bubble may open

explaining that “A HI-SPEED USB device is plugged into a non-HI-

SPEED USB hub”. Plug the USB cable into a USB 2.0 port (if

available) or just disregard the message. If you leave it plugged into

the USB 1.1 port, your scanner may scan a bit slower.

4. Your computer recognizes that a scanner has been plugged into the

USB port and automatically loads the appropriate software to run the

scanner.

If your computer is running Windows XP or Windows Vista, you will

see a message similar to the following.

USB

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 104 105

Keine Kommentare

Xerox DocuMate 515 Betriebsanweisung Seite 18