Xerox AccXES Version 10.0 Bedienungsanleitung PDF herunterladen

AccXES Version 10.0 Installation Instructions

NOTE: If you have an HFT controller with AccXES 8.0 or 8.5, upgrading to AccXES 9.1 or 9.2 will

cause you to lose the following Data Format Interpreters (DFI):

• VCGL

• Versatec Raster (VRF & VDS)

• CGM

These DFIs are no longer part of the standard system. A feature key is necessary to enable

them. The DFI Feature Keys can be purchased through Xerox Sales or an Authorized Reseller.

See Step 1 to determine if you have an HFT controller.

Note: For the Xerox 6050 and 6030 Wide Format products, one must activate the AccXES print

server by downloading the appropriate print server feature key.

Warning: If your current AccXES Version is 8.0 or lower, upgrading to AccXES 9.2 will eliminate all

existing feature keys. Once installation is complete, you will need to reinstall your feature keys. If you

are currently at AccXES 9.0 or 9.1, your feature keys will be retained.

Step 1 Determine your Hardware Configuration

There are distinct versions of firmware for each controller hardware platform. Firmware is available for the

hardware platforms as indicated below. Your hardware platform can be determined by examining the

printer configuration test print or serial number (found on the AccXES controller unit). Note your hardware

version. Note: Use the HFT firmware as this will be the correct downloadable binary for PUN controllers.

Hardware CPU (from test print) Serial Number

PUN RTT – MPC 7410 PUN-xxxxx

HFT RTT – MPC 7410 HFT-xxxxx

CNG PPC740 – 200 CNG-xxxxxx

N5T PPC740 – 200 N5T-xxxxx

EV4 MPC8240-250 EV4-xxxxxx

Step 2 Release Notes

Download, print, and read the AccXES release notes (pdf format). The release notes can be found in the

documentation section or by using the ‘See Also’ link.

Step 3 Check Disk Size and RAM Requirements

Consult the Recommended Configurations Chart (pdf file) to confirm that your Controller has the required

disk size and RAM needed for the AccXES upgrade. This chart can be found in the documentation section

or by using the ‘See Also’ link.

1 2 3

AccXES Version 10.0 Installation Instructions NOTE: If you have an HFT controller with AccXES 8.0 or 8.5, upgrading to AccXES 9.1 or 9.2 will cause

Seite 2

Step 4 Job Accounting Migration (if applicable) Warning: As a precaution, save your Job Accounting Data prior to upgrading. If you have AccXES 7.5 o

Seite 3

Step 6 Install or Upgrade to Version 10.0 Download the AccXES_10_FW.ZIP file. Unzip the file. Follow the instructions in the AccXES customer relea

Keine Kommentare

Xerox AccXES Version 10.0 Bedienungsanleitung